Skip to content

Priority fixes: what to change first in your mix

Send feedback

Last updated 3 min readTags:MixingAI Coaching

Understand Sonalix priority fixes, how to use the suggested settings, and what to listen for when you test each change in your mix.

Priority fixes are Sonalix’s ranked recommendations for improving your mix. They suggest what to change, give you settings to try, and explain what to listen for afterwards.

Start with the first recommendation. Test each change before moving on; the aim is an audible improvement, rather than a completed checklist.

What each priority fix tells you

The report lists five priority fixes in order of estimated impact. Each has four parts:

Part What it tells you
Issue The problem to investigate.
Description How it may affect the sound of your mix.
Fix An adjustment to try, with suggested settings.
What to listen for The audible change to check for when you compare versions.

Suggested settings may include an EQ frequency, a gain change in decibels, a Q value, or a compressor setting. These give you a practical starting point. They still need to suit the material you are working on.

How to read a recommendation

Here is an illustrative example, rather than an analysis of a real track:

Issue: Low-mid build-up

Description: Too much energy in the low mids may make the mix sound boxy and obscure quieter parts.

Fix: Try a broad EQ cut of 1 dB at 280 Hz, with a Q of 1.0. Compare it with the EQ bypassed at a similar listening level.

What to listen for: Parts should be easier to distinguish, while the mix should retain its warmth and weight.

The frequency tells you where to try the adjustment. The gain sets its amount. Q controls the width of the affected frequency range; lower values produce broader changes.

If the cut makes the mix sound thin, reduce it or undo it. A setting is useful only if the result sounds better.

Why the order matters

The first fix is the report’s suggested starting point. A substantial change can affect whether later recommendations remain useful.

For example, less bass may make the upper frequencies seem more prominent. Reassess the tonal balance before you apply a separate recommendation to increase treble.

Read the whole list for context, then work through it one change at a time. After a substantial adjustment, listen again and consider running a fresh analysis before continuing.

How to test a priority fix

  1. Save a version of your mix. Keep the original available for comparison.
  2. Find a passage where you hear the problem. Listen in the full mix first. Solo individual tracks if you need to investigate further.
  3. Try the suggested adjustment. Use the supplied values as your starting settings, then adjust them by ear.
  4. Compare at a similar loudness. Switch the processing on and off. A louder version can seem better simply because it is louder.
  5. Check the expected improvement. Listen for the change described in the report, and check that other parts still sound right.
  6. Keep, revise or undo the change. If you cannot hear a benefit, you need not keep it. Check other sections of the track before you decide.

What the recommendations can tell you

Sonalix bases its recommendations on analysis of the uploaded audio. A suggested explanation, such as kick and bass masking each other, needs to be checked in your session. The report does not establish the cause merely by naming an instrument.

Likewise, a suggested compressor ratio does not prove which settings were used in the original mix. Check the processing already in your session before changing it.

Once you have tested the priority fixes, review the minor adjustments. Some may still be useful; others may no longer be needed after your earlier changes.

Was this page helpful?

    Type to search titles, headings and summaries.