Dither: when to use it and when to leave it off
Last updated 2 min readTags:Getting startedExport
Why dither protects quiet fades during bit-depth reduction, and where it belongs in the export chain.
Use dither when you make a final reduction to a lower integer bit depth, such as a 24-bit or float master delivered at 16-bit. Put it immediately before the final quantisation, after level changes, fades, limiting and any sample-rate conversion.
What you hear on a fade
When the export rounds samples to fewer available amplitude steps, the error can follow the signal. On a very quiet fade or reverb tail, that can sound grainy or break up as the level approaches silence.
Dither adds a small amount of random noise, on the scale of the least significant bit, before rounding. This turns signal-related error into a low noise floor and can preserve the shape of a fade below one quantisation step. The theoretical range of 16-bit PCM is about 96 dB. The difference is easiest to hear on quiet material. See bit depth.
| Export | What to do |
|---|---|
| Final 16-bit file from 24-bit or float | Apply dither once |
| 24-bit mix for mastering or analysis | Leave the optional dither off unless your engineer asks for it |
| 32-bit float intermediate file | Leave it off |
| Unchanged 16-bit file resaved at 16-bit | Leave it off |
| Sample-rate conversion and final bit-depth reduction | Convert the rate first, then dither at the reduction |
A float-to-24-bit export still quantises the signal. At that depth the error is ordinarily negligible for a working mix, which is why Sonalix recommends an undithered 24-bit upload. The 16-bit and 24-bit exports in one Sonalix test gave identical readings. That test compared bit depths and did not isolate dither.
Which type to choose
TPDF (triangular) dither is the straightforward choice for routine delivery. Noise-shaped dither pushes more of the noise into less audible frequency ranges. Reserve it for a final file, since later processing can change the noise you hear.
Check the limiter, master-bus plug-ins and DAW export dialogue. If several offer dither, enable it only at the final reduction. For files going to an engineer, read how to prepare a mix for mastering. For Sonalix, follow the mix export settings.