Skip to content

How to mix on headphones

Send feedback

Last updated 3 min readTags:MixingMonitoringHeadphones

Learn how to judge stereo width, tonal balance and bass on headphones, and what to listen for when you check your mix on speakers.

You can mix on headphones from start to finish. They’re especially useful in an untreated room because you hear the mix without the room’s reflections and bass peaks or dips. The same mix can still feel wider on headphones than on speakers, and the bass can change if the ear pads sit differently. A familiar reference track and a few short playback checks will help you decide what, if anything, to adjust.

Check stereo width and mono separately

With speakers, sound from each speaker reaches both ears. On ordinary stereo headphones, the left channel goes to your left ear and the right channel to your right. Hard-panned parts can feel more isolated as a result. If two guitars sound much further apart than you intended, compare them with a familiar mix before you bring the pans in.

Crossfeed blends a little of each channel into the other to approximate what happens on speakers. If you use it, switch it in briefly to check whether the spacing and balance still make sense.

A mono check answers a different question. When the left and right channels are summed, does anything important get much quieter, turn hollow or disappear? If a stereo synth nearly vanishes, try bypassing its widener and check again. Some level changes are expected when you sum to mono, so listen for parts that lose their place in the mix. See how to check mono compatibility.

Compare tonal balance on the same headphones

Pick one or two tracks that are close to the sound you want. Match the playback loudness of comparable sections, such as chorus against chorus, and switch between them on the same headphones. If both the reference and your mix sound bright, listen on another system before cutting treble. If only your mix sounds bright, compare the vocal, cymbals and other likely sources before reaching for the mix-bus EQ.

Headphone correction software uses EQ to bring a model’s measured response closer to a target curve. A model profile is a starting point because fit, worn pads and differences between units can change what you hear. If you use correction, compare your mix and reference through the same monitoring settings. Put correction and crossfeed on a dedicated monitor output if your setup has one. If they’re on the master bus, bypass them before export, along with any mono switch.

Check the headphone fit before changing the bass

If the low end changes when you reseat the headphones or move your glasses, find a consistent fit before you reach for EQ. Headphones can reproduce deep bass, but they give you much less of the physical sensation you get from a loudspeaker system with strong low-frequency output.

If your mix seems bass-light next to the reference, use a spectrum analyser to see whether it has less energy in the low end. Read the trace alongside what you hear. A sustained synth bass and a short kick can produce very different readings, even when both are balanced in their respective mixes.

Keep the level down and take breaks

Work at a low, comfortable level and take regular breaks with the headphones off. When you come back, replay a familiar section before making another EQ move. A harsh sound that bothered you at the end of a long session may sit differently after a break.

Check the export on another system

  • On a phone or laptop speaker, check that the lead vocal is clear and you can still follow the bass line. If the bass disappears, go back to the mix and check whether it has enough upper harmonics to be audible or whether another part is masking them. A boost in the sub-bass may make very little difference on a small speaker.
  • On speakers that reproduce low bass, check the level of the kick and bass against the rest of the mix. Listen to how the hard-panned parts sit when the sound comes from in front of you.

Play your reference on the same system. If both tracks lose weight on a phone, that’s useful context. If your bass line is the only one that disappears, you have a specific problem to investigate.

    Type to search titles, headings and summaries.