Skip to content

Why does my master pump?

Send feedback

Last updated 2 min readTags:TroubleshootingMixing

Trace rhythmic gain changes to the kick, the compressor or limiter, and its release.

If the hats, vocal and ambience all duck when the kick hits and swell between hits, watch the gain-reduction meter on the mix bus. A repeating peak can drive compression across the whole mix. The return to normal gain is what you hear as the swell.

Find the processor and what triggers it

Loop the loudest section. Bypass the final limiter, then the bus compressor, one at a time. Match playback level as you go. Where two stages respond to the same hits, their gain changes can compound. See limiting and bus compression.

Once you know which processor moves, mute or lower the kick briefly and watch its meter. If the compressor offers a detector high-pass filter, try it with the kick back in. The filter changes which frequencies drive the detector. It leaves the audible kick in the mix. If the kick still dominates, adjust its peak or its level against the bass before the master. See kick and bass.

Set depth before release

Back off the input or raise the threshold so the processor takes less off each hit. Then audition release times. A short release can make the rebound conspicuous. A long release can keep the next beat down. Listen for the vocal or reverb tail between kicks as you lengthen the release, or try auto release. Attack governs the response as gain falls, and plug-ins differ in what their timing values represent. See dynamic range compression.

If a chorus limiter is pulling down the whole mix on each kick, try reducing its input by a couple of dB before adjusting release. If you still need density, compare parallel compression on the drums. Fast-attack compression can reduce crest factor and longer-term contrast, as reported in a 2014 AES study. See over-compression if the whole section has lost its lift.

For an intentional dance or hip-hop effect, sidechain the bass or pad and decide how much of the mix should move. If you hear the effect on just one system, check that playback chain. Related checks cover a loud but flat master, distortion after upload and muddiness.

Was this page helpful?

    Type to search titles, headings and summaries.