Skip to content

Mastering for vinyl

Send feedback

Last updated 3 min readTags:MasteringDelivery

Plan your vinyl side lengths and track order, check bass and sibilance, and find out what to send your cutting engineer.

Work out the running time of each side, including gaps, and send the proposed sequence to your cutting engineer before you finalise the master. Side length affects how loud the engineer can cut the record. Track order matters too, because bright, dense material is harder to play cleanly near the label.

How much music fits on a vinyl side?

A louder cut generally needs more space between adjacent turns of the groove. A longer side has to fit more turns into the available space, so the engineer may have to cut it at a lower level. Surface noise can then be more apparent against the music.

Disc Makers publishes these figures for its own service. Use the preferred times to plan your sides and confirm the upper limit with your cutting house. A side with sustained, heavy bass may need more room than a quieter side of the same length.

Record size and speed Preferred time per side Disc Makers’ maximum
12-inch at 33⅓ rpm 15–18 min 22 min
12-inch at 45 rpm 9 min 12 min
7-inch at 33⅓ rpm 4½ min 6 min
7-inch at 45 rpm 3½ min 4½ min

If one side runs long, try moving a track to the other side. If the order matters, ask how the extra time would affect the cut before you change it.

Check the bass and sibilance

Listen to the low end in mono. Strong left-right differences in the bass can produce large vertical movements in the groove, which may cause a stylus to mistrack. If the kick or bass loses weight when you switch to mono, check for a stereo widener, chorus or a layered bass part that cancels in the sum. Correct the source where you can. Ask the cutter before applying a fixed bass-to-mono crossover or a steep high-pass filter to the whole mix. Mono compatibility

Listen for sharp consonants and cymbal hits. A sharp ‘s’ can turn into a rasp on playback if the stylus struggles to follow the groove. If a few syllables are responsible, turn them down or de-ess the vocal before reaching for a high-shelf cut across the whole master. Sibilance and de-essing

Put the hardest tracks to cut earlier

The record spins at a constant rate, but each turn of the groove is shorter near the label. There is less groove length per second of music, which makes high frequencies harder for the playback stylus to trace. If you have room to change the order, put the track with dense cymbals or a bright, loud chorus towards the outside. A track with softer highs is a better candidate for the end of a long side.

Can you use the streaming master?

Sometimes. Ask the cutter to review the approved master. If it has been heavily limited for loudness, supply an alternate with less final limiting if you have one. Turning down a limited file reduces its level, but it cannot restore the peaks the limiter removed. The cutting engineer sets the level of the cut.

What to send the cutting engineer

  • Audio in the agreed format. Confirm file type, sample rate and bit depth. A 24-bit WAV at the project’s native sample rate is a common choice.
  • The files in the agreed layout. If the cutter wants one file per side, label each clearly and include the final gaps, fades and any crossfades. If they want separate tracks, name them in order, such as A1_Title.wav and B1_Title.wav.
  • A cue sheet. Give the side, track order, titles, start times and total running time for each side. Include the record speed and catalogue number if requested.

Confirm the sequence before the cut. If you receive a test pressing, listen through both sides and check the track boundaries and the last track on each side.

Sources

Was this page helpful?

    Type to search titles, headings and summaries.