Monitoring level and ear fatigue: how loud should you mix?
Last updated 4 min readTags:MixingMonitoringListening
Set a repeatable monitor level, check your mix quietly, and learn what a sound level meter can tell you about listening volume and exposure.
Mix at a comfortable level you can return to. Play a track you know well and turn the monitors down until the main parts are still easy to follow and you can talk to someone beside you without raising your voice. Mark that setting on your monitor controller. Use it for most of your balance, EQ and compression decisions.
Why the same mix sounds different when you turn it down
At low playback levels, deep bass is harder to hear relative to the midrange. Some treble detail can become less apparent too. Equal-loudness contours describe how our sensitivity to different frequencies changes with level. That is one reason the same chorus can sound bass-heavy at one volume and vocal-heavy at another. ISO 226:2023
If the kick loses some weight when you turn down, compare it with the kick in a familiar track at roughly the same perceived loudness. If both lose weight, that may be what you would expect at that level. If yours all but disappears, return to your usual setting and check whether the bass is masking it. Tonal balance
How to set a repeatable monitor level
Start with a familiar track because you already know what its bass, vocals and cymbals sound like. Keep the track and its playback gain the same when you use it to recheck your setting. If a mastered reference is much louder than your mix, lower the reference in your DAW before comparing them. Make changes to listening volume with your monitor control so the mix bus level stays where you set it.
If you want a measured reference, start with the monitor volume low. Play a known, band-limited pink-noise file at −20 dBFS RMS through one speaker at a time. Put a sound level meter at ear height where you sit, select C-weighting and Slow response, and record the reading from each speaker. There is no universal target. For its calibration method, Sound On Sound gives 74 to 76 dB SPL (C-weighted) as examples for smaller rooms. Project studio monitor calibration
Then play a loud passage of the actual mix through both speakers. The same knob setting can produce very different levels with pink noise, a quiet verse and a dense chorus. For an estimate of listening exposure, use an A-weighted average (LAeq) over a representative stretch of the session. A calibrated meter is preferable if you need an accurate reading. NIOSH sound level meter guidance
What to check at each volume
| Playback level | What to listen for |
|---|---|
| Usual working level | Make balance, EQ and compression decisions here. Return to this setting before acting on something you notice at another volume. |
| Quiet | Play a verse or chorus. Can you still follow the words, hear the snare and make out the bass line? If you want to know how the mix sounds on a phone, play it on a phone. |
| Slightly louder, if needed | Use the same short passage to check a specific concern, such as a kick that overwhelms the bass line or a vocal that gets sharp. Return to your working level after the check. |
If one bass note booms or vanishes at your desk, try moving your head forwards or backwards. A large change with position points to the room or speaker placement. Check on headphones or another system before reaching for EQ. Genelec’s guide to monitor placement
Ear fatigue, breaks and hearing exposure
If you find yourself turning the monitors up or adding treble to make things sound clear again, step away for a quiet break. Ten minutes after roughly an hour is a workable routine. When you come back, play the same passage at your usual level before deciding whether it still needs a change.
Exposure depends on both level and time. The US National Institute for Occupational Safety and Health (NIOSH) uses 85 dBA averaged over eight hours as a workplace exposure limit. At 88 dBA the corresponding duration is four hours. Those figures describe workplace exposure and use A-weighted averages. Use moderate levels for long sessions and allow for loud sound you encounter elsewhere in the day. NIOSH noise exposure guidance
On headphones, use the same listening routine at a comfortable, repeatable setting. A room meter cannot measure the level at your ear under the headphones. Use the exposure estimate if your device provides one for your headphones. WHO safe listening guidance
If your ears ring after listening, stop and give them a quiet break. If ringing persists or recurs, get your hearing checked. Seek urgent medical advice if your hearing drops suddenly. WHO on warning signs of hearing loss · NHS hearing loss guidance