A typical mastering chain and how to set it up
Last updated 3 min readTags:MasteringDelivery
Learn how to order a mastering chain, when to use EQ, compression and limiting, and how to check the loudness and true peak of your export.
A mastering chain is the sequence of processors you apply to a finished mix. A common order is EQ → compression → saturation or stereo adjustment → limiter, followed by a loudness and true-peak meter. Every processor is optional. If the mix sounds good and only needs a little more level, you may get there with a limiter alone.
Listen to the mix first
Play the whole mix and pick a reference track with a similar sound. Route it around your mastering plug-ins and match its playback loudness to the mix. Compare similar sections and listen for differences you would actually want to change. If the bass is too loud throughout, a small EQ cut may be enough. If the bass loses definition only when the kick enters, go back to those tracks in the mix.
1. EQ
Use mastering EQ for problems you can hear across the mix. A broad cut of around 1 dB is a reasonable first try if the whole track sounds thick in the low mids. A narrow cut suits a persistent ring at a particular frequency. Use a high-pass filter when there is rumble to remove, and check that the lowest bass notes still have their weight. One EQ can handle both corrective cuts and broader tonal changes.
EQ before compression changes what the compressor responds to. If the kick makes the whole mix dip and there is too much low end, a bass cut before the compressor can reduce both problems. If you like how the compressor reacts and only want a tonal change, try the EQ after it.
2. Compression
Try bus compression if the loudest hits stick out or the mix changes level more abruptly than you want. Start around 1.5:1 or 2:1, with an attack of 10–30 ms. Lower the threshold until the louder passages trigger about 1–2 dB of gain reduction. Adjust the release by ear. If the vocal swells back up after every kick, ease off the gain reduction and try a different release time.
Match the output loudness to the bypassed signal before comparing. If you prefer the way the snare hits with the compressor bypassed, try a slower attack or less gain reduction. If the mix already has the movement you want, skip this stage.
3. Saturation and stereo adjustment
Try a little saturation if you want the mix to sound denser or slightly rougher. Match the output level and listen to the vocal and cymbals. Back off if the consonants turn harsh or the cymbals start to sound gritty.
If you adjust the width, compare the original and adjusted versions in stereo and again in mono. Listen for important parts that recede or change tone when the left and right channels are summed. The mono compatibility guide explains how to check whether the change comes from the width processor or the mix itself.
4. Limiting
Set the limiter near the end of the chain, after EQ and other effects that can raise peaks. Enable true-peak limiting if your plug-in offers it. A ceiling of −1 dBTP is a practical starting point for streaming. Spotify’s mastering guidance recommends staying below −2 dBTP for masters louder than −14 LUFS integrated.
Raise the limiter input gain or lower its threshold, depending on the plug-in. Listen to the loudest section as you do it. If the kick loses its attack, the mix audibly dips on loud hits or the bass starts to distort, back off. Check against the bypassed mix at the same playback loudness before settling on the amount of limiting.
Check the exported master
Compare the full chain with the unprocessed mix at the same playback loudness. Pay particular attention to the changes you wanted to make in the first place. If you are unsure what a plug-in contributes, bypass it and listen again at matched loudness.
Measure integrated loudness and true peak on the exported file. Sample-rate conversion can change the peak level, so check the file you actually plan to deliver against its delivery specification. Listen through the export for distortion, clicks at edits and any notes or reverb tails cut off at the end.