Headroom in mixing: how much should you leave?
Last updated 3 min readTags:MixingLevelsHeadroom
Learn where headroom matters when recording, mixing and exporting, when to trim the mix bus, and how peak targets differ for premaster and release files.
Headroom is the gap between the highest peak and the clipping point at a given stage. A digital signal that peaks at −6 dBFS has 6 dB of sample-peak headroom below full scale. The figure tells you how far the highest sample sits below the ceiling. Two mixes with the same peak can have quite different loudness readings.
If you’re sending a mix for mastering, peaks around −6 dBFS are a sensible starting point. Follow your engineer’s instructions if they specify a level. If you’re preparing the release master yourself, check the exported file against the destination’s true-peak limit.
Leave room for a louder take
Ask the performer to play or sing the loudest part, then set the interface gain. Peaks around −12 dBFS during that check are a reasonable starting point at 24-bit. Leave more room if the source is unpredictable, such as a drummer who hits harder once the take starts. A clipped input stays clipped when you turn the recorded track down.
Check the level going into your plug-ins
An EQ boost or a compressor’s make-up gain can raise the level feeding the next plug-in. That matters if the next processor responds to input level, as a compressor or tape emulation does. If a plug-in is distorting more than you intended, turn down the signal before it. Lowering its output only makes the distortion quieter.
When you compare a plug-in with its bypassed signal, use its output gain to bring both to roughly the same perceived loudness. Then check the level going into the next plug-in. The peak may change even when the two versions sound equally loud.
Should you trim before or after bus processing?
Play the loudest section with the full mix running and check the mix bus. Several tracks can add up to a high peak even when each one has plenty of room on its own. A floating-point DAW bus can carry peaks above 0 dBFS, but the signal needs to come down before playback through the converter or export to a fixed-point file such as a 24-bit WAV. A plug-in in that path can distort earlier.
Suppose a snare hit drives the mix-bus compressor harder than you want. Lower the gain before the compressor and listen again, since the gain reduction will change. If the mix sounds right and its output peaks at −1 dBFS, a 5 dB trim after the mix-bus processing brings the peak to −6 dBFS without changing the balance or the compressor’s response.
Check your peaks on export
If you’re sending a mix for mastering
Ask for the engineer’s preferred file format and level. A 24-bit WAV at the session’s sample rate is a reasonable default. Keep bus processing that gives the mix its intended sound. If you added a final limiter solely to make the mix louder for listening, export with it bypassed. If the limiter is part of the sound, ask whether the engineer would like both versions.
If you’re exporting a release master
A sample-peak meter reads the highest stored sample. A true-peak meter estimates how high the reconstructed waveform can rise, including between samples. Lossy encoding, such as AAC, can push those peaks higher still.
Follow the delivery specification. Spotify’s mastering guidance recommends keeping true peak below −1 dBTP. For masters louder than −14 LUFS integrated, it recommends staying below −2 dBTP.
If you use a limiter to control peaks, use its true-peak mode if available. Measure the exported file itself. The limiter’s ceiling is a setting, and the meter on the finished file tells you what you actually delivered.