Skip to content

How to export a mix for analysis

Send feedback

Last updated 3 min readTags:Getting startedExport

Export a full-length lossless mix for Sonalix with the right sample rate, bit depth and channel count.

Export the full mix as a 24-bit stereo WAV, AIFF or FLAC. Keep your session rate if it is 44.1 or 48 kHz. Use a 48 kHz copy for a higher-rate session. Leave normalisation off and keep the mix-bus processing you already chose for this version.

Setting What to export
Format WAV, AIFF or FLAC. All three gave identical results in a Sonalix test
Bit depth 24-bit PCM by default. 32-bit float WAV is also supported
Sample rate 44.1 or 48 kHz. See sample rate
Channels One stereo file for a stereo mix. Mono files are also accepted
Range From the start of the song to the end of the longest tail
Processing Existing mix processing only. Leave export normalisation and optional dither off for a 24-bit analysis copy

Make and check the bounce

  1. Set the export range so the song starts in the right place and the last reverb or delay tail can decay. Export one mix file.
  2. Disable options such as Normalise or Loudness match. Keep a limiter if it is part of the sound you want reviewed. An extra limiter changes the peaks and dynamics the report measures.
  3. Give it a versioned name such as song-mix-v3.wav. Play the last 10 seconds, compare the duration with the session and check the file properties. If loud passages sound distorted, check for clipping in the export.
  4. Upload the mix. When you compare revisions, use the same export settings. For a mix going to an engineer, see preparing a mix for mastering.

With 32-bit float, Sonalix can measure sample values above 0 dBFS. Reduce gain before a fixed-point export if those values would otherwise clip. See dither if you are also making a separate 16-bit delivery file.

Why the original lossless export matters

Sonalix measures what it decodes. In one test on the same master, a 128 kbps MP3 read 19.3 dB lower in the test's High band than the WAV. Its spectral centroid was 4,624 Hz against 6,231 Hz, and its integrated loudness was 0.43 LU lower. Those are results for one encode. A WAV made from that MP3 still contains the encoder's changes. See supported file formats.

Upload limits

Sonalix accepts WAV, AIFF, FLAC, OGG, MP3 and M4A, with one or two channels. The duration limit is 15 minutes and the default size limit is 300 MB. An upload also fails if no signal clears the −70 LUFS gate.

Stereo WAV MB per minute Four minutes Time to reach 300 MB
24-bit, 44.1 kHz 15.9 64 MB About 18.9 min
24-bit, 48 kHz 17.3 69 MB About 17.3 min
32-bit float, 48 kHz 23.0 92 MB About 13.0 min
24-bit, 96 kHz 34.6 138 MB About 8.7 min

The size estimates exclude container overhead. For 24-bit WAV at 44.1 or 48 kHz, the duration limit arrives first. If size is the problem with a PCM file, try FLAC. A rejected upload or engine failure does not use a review credit. See plans and review credits.

Was this page helpful?

    Type to search titles, headings and summaries.