CD Red Book standard: how to prepare a CD master
Last updated 3 min readTags:MasteringDelivery
Prepare a 16-bit, 44.1 kHz audio CD master. Get the order of sample-rate conversion and dither right, set track starts and gaps, and check your DDP.
The Red Book is the specification for audio CDs (CD-DA), published internationally as IEC 60908. An audio CD uses 16-bit, 44.1 kHz stereo PCM and can hold up to 99 tracks. When you author a CD, you set where each track starts, what plays between tracks and which codes and titles go on the disc.
Check what your pressing plant accepts
Ask the plant for its maximum running time and preferred delivery format before you author the disc. Early CDs were designed to hold about 74 minutes. Many plants accept longer programmes, and their limits can differ by service. Include gaps in your running time and check the complete sequence if you are near the limit.
- DDP image. Disc Description Protocol is a set of files containing the audio and disc layout, including track starts and any codes or CD-Text you have entered. Send the complete set as instructed, with the PQ sheet (a report of track timings and codes) if requested.
- Individual audio files. Some plants will author the disc for you from WAVs and a track list. Supply the running order and any instructions for gaps, transitions and metadata. For a live set or a continuous mix, agree how to supply the uninterrupted audio and track start times.
- Physical master. Some plants also accept an authored audio CD with a track sheet. Check before posting one.
Prepare the audio
- Finish the sequence at your working resolution. Set the relative levels, fades and crossfades. Audio CDs have no built-in loudness normalisation, so listen to how the tracks follow one another at a fixed playback volume.
- Convert to 44.1 kHz if your master is at a different sample rate. Keep the higher bit depth for now and recheck true peak after conversion. If peaks are too close to clipping, adjust the level before the final export.
- Apply dither when you export to 16-bit. Dither adds a little noise to prevent distortion from rounding at low levels. Use one dither stage at the final bit-depth reduction. If you need to change a fade or level afterwards, make the edit in the higher-resolution project and export again. Use the same approach if your authoring software renders directly to DDP.
Set track starts and add metadata
The index 01 marker is where playback starts when someone selects a track. Index 00 marks a pregap, where present. The first track has a pregap of at least two seconds, which authoring software may insert automatically. Check how your software handles it before adding silence yourself.
For a live album, you might place the next track start just ahead of the first note, with the applause from the previous song still audible. Play through the join, then skip straight to the new track. Both should sound intentional.
Add the release metadata where applicable:
- ISRC identifies the recording on a track.
- UPC or EAN identifies the release and can be stored on the disc.
- CD-Text stores details such as artist and track names for players that display them.
Check the exported master
Open the exported DDP in a DDP player. Listen from start to finish for distortion, cut-off fades and unintended silence, then use track skip to check each start. Compare the order, total running time and any codes or CD-Text with your approved track list. For a modern master, leave the legacy pre-emphasis flag off. If the plant authors the disc, check its proof against the same track list.
Sources
- IEC 60908, Compact disc digital audio system
- Philips, The Emergence of the Compact Disc
- Sony Music, audio submission guidelines and Disc Makers, preparing a physical audio master
- Sonoris, DDP Player manual and Steinberg, exporting a DDP image
- iZotope, dithering and bit-depth conversion
- IFPI, ISRC Handbook